South Carolina SCDMV CDL General Knowledge Practice Test 6
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. What must a written driver vehicle inspection report cover at the end of the day?
Show answer
Answer C: Any defect or deficiency that would affect safety or could cause a mechanical breakdown
The report identifies the vehicle and lists defects that affect safe operation or could lead to a breakdown, so they are repaired before the next trip.
-
2. What is axle weight?
Show answer
Answer C: The weight carried to the ground by one axle or one set of axles
Axle weight describes how the load is shared among the axles that carry it to the road, not how much the whole vehicle weighs.
-
3. What does the federal bridge formula do?
Show answer
Answer C: It reduces the weight allowed on a group of axles as those axles get closer together
Axles bunched together concentrate the load on a short span of a bridge, so the formula lowers the allowable weight as the spacing shrinks.
-
4. You pick up a trailer that another driver dropped in the yard. What must you do before pulling it?
Show answer
Answer B: Inspect it yourself, because you are responsible for the whole vehicle you drive
Responsibility follows the driver who moves the vehicle, and a trailer that has stood in a yard may have lost air, developed a flat tire or been damaged.
-
5. How often must every commercial motor vehicle receive a periodic inspection?
Show answer
Answer C: At least once every twelve months
Federal rules require each commercial motor vehicle to pass a periodic inspection at least once in every twelve month period.
-
6. How does a typical escape ramp stop a runaway vehicle?
Show answer
Answer B: With a bed of loose gravel or sand, often on an upgrade
Escape ramps use deep loose material, usually combined with a rising grade, so the vehicle is slowed gradually instead of being stopped by impact.
-
7. After starting a trip, when must a driver first re-inspect the cargo and the devices holding it?
Show answer
Answer A: Within the first 50 miles
Federal rules require a check of the load and its securement within the first 50 miles, because settling and vibration loosen straps and chains early in a trip.
-
8. When is tire pressure most accurately compared with the recommended figure?
Show answer
Answer B: When the tires are cold, before the vehicle has been driven
Recommended pressures are cold pressures, so a reading taken before the tires have heated up is the only one that can be compared directly.
-
9. What actually lowers the amount of alcohol in the bloodstream?
Show answer
Answer B: Time
The liver removes alcohol at a fixed rate, so nothing but the passage of time reduces blood alcohol concentration.
-
10. What tells a driver when to shift up in a vehicle with a manual transmission?
Show answer
Answer C: Engine speed in rpm together with road speed
Shift points are judged from engine rpm and road speed, using the operating range the manufacturer specifies for that engine.
-
11. A 40 foot straight truck and a 70 foot tractor-trailer make the same right turn. Which needs more room and why?
Show answer
Answer B: The tractor-trailer, because the longer the vehicle the farther inside the rear wheels track
Off-tracking grows with the distance between the front and rear axles, so the longer combination cuts the corner much more sharply and needs extra room.
-
12. What is the correct order for a double clutch downshift?
Show answer
Answer D: Release the accelerator and push the clutch to reach neutral, release the clutch and press the accelerator to raise engine speed, then push the clutch again and select the lower gear
A lower gear turns faster than the one being left, so engine speed has to be raised in neutral before that gear will engage cleanly.
-
13. You are inspecting the vehicle alone and need to confirm that the stop lights work. Which method is correct?
Show answer
Answer A: Have a helper press the brake pedal, or apply the brake in a way that keeps it on while you check from outside
Stop lights are checked from outside the vehicle while the brakes are applied, so a helper or a brake held on is needed.
-
14. An unblocked crate 4 feet long and weighing 900 pounds needs at least how many tiedowns?
Show answer
Answer D: One
An article 5 feet or less in length and 1,100 pounds or less in weight is covered by a minimum of one tiedown.
-
15. How does the working load limit of a tiedown relate to the force that would break it?
Show answer
Answer B: The working load limit is a fraction of the breaking strength and is the figure you use
The working load limit is set well below the point at which the device would fail, and securement is always calculated from the working load limit, never from breaking strength.
-
16. Why does a load need to be balanced from side to side?
Show answer
Answer B: Because a heavy side raises the rollover risk and can overload the tires and springs on that side
An uneven load tips the balance of the vehicle in curves and pushes the tires and suspension on the loaded side past their rating.
-
17. Which winter preparation matters most for keeping the road in view?
Show answer
Answer D: Working wipers, washer fluid and a working defroster
Slush and road spray coat the windshield within minutes in winter, so wipers, washer fluid and the defroster are what keep any view at all.
-
18. The engine has overheated and you need to check the coolant. What is the safe procedure with a pressurized radiator cap?
Show answer
Answer A: Shut the engine off, let the system cool, protect your hands, turn the cap slowly to its first stop so pressure escapes, step back, then remove it
A hot pressurized system throws steam and boiling coolant out of the opening, so the pressure is released slowly and only after the engine has cooled.
-
19. You are hauling an open box of loose gravel. What does that load require?
Show answer
Answer A: A cover, so that material cannot blow off or spill onto the road
Loose material that can be blown or spilled has to be covered so it does not come out of the body and strike traffic behind.
-
20. Why does the manual insist on a firm grip with both hands on opposite sides of the steering wheel?
Show answer
Answer A: A hard bump can pull the wheel out of a loose grip
Hitting a curb or a deep pothole can jerk the wheel violently, and only a firm two-handed grip keeps the vehicle under control when that happens.
-
21. On a two lane road carrying traffic in both directions, where do the three warning devices go?
Show answer
Answer C: About 10 feet from the vehicle on the traffic side, 100 feet behind and 100 feet ahead
Traffic can approach from either direction, so one device goes close to the vehicle and one is placed about 100 feet away in each direction.
-
22. How do you avoid the sharp lurch that comes at the very end of a stop in a heavy vehicle?
Show answer
Answer A: Ease off the brake pressure just before the vehicle actually comes to rest
A smooth stop is finished by reducing pedal pressure as the vehicle settles, so the suspension does not rock the cab and the load forward.
-
23. A dock crew loads all of the freight at the very back of a 48 foot van trailer. What are the two consequences?
Show answer
Answer A: The steering axle is relieved of weight and steering becomes light, and the trailer axles may go over the limit
Weight placed far to the rear lifts weight off the front of the combination, so the steering goes light while the trailer axles take too much of the load.
-
24. As a long vehicle goes around a corner, how do the rear wheels travel compared with the front wheels?
Show answer
Answer A: They follow a tighter path, closer to the inside of the turn
The rear wheels off-track toward the inside of the turn, and the longer the vehicle the bigger the difference, which is why the front must swing wide enough to keep the rear off the curb.
-
25. The shipper hands you the placards for a load that needs them. Who puts them on the vehicle?
Show answer
Answer C: The driver, who must also make sure they are the correct ones and are readable
The shipper supplies the placards, but it is the driver who must place them on the vehicle and confirm that they match the load and can be read.
-
26. On a scale, your loaded truck is well under the gross weight limit, but one axle is above the limit for that axle. What does this mean?
Show answer
Answer D: The vehicle is overloaded and the load must be shifted or reduced before you drive on
Each axle and axle group has its own limit and each must be respected; being under the gross limit does not excuse an overloaded axle.
-
27. What is the coupling device weight rating on a vehicle?
Show answer
Answer A: The most weight that the coupling on the vehicle is rated to pull
The coupling device rating is a limit on how much weight the coupling may tow, and it is one of the ratings that has to be respected when a combination is loaded.
-
28. Around a tractor-trailer, where are the blind areas that other drivers most often sit in unseen?
Show answer
Answer A: Along the right side and directly behind the trailer
The blind areas to the right of the cab and behind the trailer are the largest, which is why other drivers should never linger there.
-
29. Which vehicle condition makes hydroplaning more likely?
Show answer
Answer C: Tires that are worn or underinflated
Tread depth and correct pressure are what let a tire push water aside, so worn or soft tires lift onto the water film at lower speeds.
-
30. Which situations call for a mirror check in a commercial vehicle?
Show answer
Answer A: Every lane change, turn, merge and tight maneuver
Mirrors must be checked regularly and always before, during and after any movement that changes the path of the vehicle.
-
31. Besides the hours when the law requires them, when should headlights be switched on?
Show answer
Answer A: Any time visibility is poor, such as in rain, fog or at dusk
Headlights are used to be seen as much as to see, so they belong on whenever light or weather makes the vehicle harder to spot.
-
32. What is checked about the clutch and the gearshift during the in-cab inspection?
Show answer
Answer D: That the clutch free play is within the range the manufacturer specifies
Too little or too much clutch free play causes slipping or dragging, either of which can leave the driver unable to select the gear a hill demands.
-
33. How are the headlights, marker lights and turn signals checked during the seven-step inspection?
Show answer
Answer A: The engine is shut off, the parking brake is set, the lights are switched on and then checked from outside the vehicle
The lights are switched on with the vehicle secured, then the driver walks around and confirms each lamp actually works and is clean.
-
34. Total stopping distance is made up of which parts?
Show answer
Answer A: Perception distance, reaction distance and braking distance
The vehicle travels while the hazard is recognized, while the driver moves to the pedal, and again while the brakes slow the vehicle.
-
35. Two tires in a dual set have noticeably different diameters. Why is that a problem?
Show answer
Answer C: The larger tire carries more than its share of the load and can be overloaded
The taller tire touches the road first and takes most of the weight, so it runs overloaded and hot while the smaller one does little work.
-
36. Why does a cracked frame rail or cross member make a vehicle unsafe?
Show answer
Answer B: The frame carries the whole load, and a crack can spread until the structure fails
The frame is the backbone that supports the body, the load and the running gear, so a crack in it is a structural failure that grows with every mile.
-
37. Which endorsements may appear on a South Carolina commercial learner's permit?
Show answer
Answer A: Only N for tanker, P for passenger and S for school bus
SCDMV limits commercial learner's permit endorsements to N (tanker vehicle), P (passenger vehicle) and S (school bus).
-
38. What should the ammeter or voltmeter show once the engine is running?
Show answer
Answer D: A reading in the normal charging range
With the engine running, the alternator should be charging; a discharge reading or an abnormal charge level means an electrical fault.
-
39. If an intersection has two lanes marked for left turns, which one should a large vehicle use?
Show answer
Answer D: The right hand of the two turning lanes
The outside turning lane leaves room for the rear of the vehicle to swing without striking a vehicle in the adjacent lane.
-
40. During the walkaround you notice a bulge in the sidewall of a trailer tire. What does it indicate?
Show answer
Answer B: Damage inside the tire, which can lead to a sudden failure
A bulge means the internal structure has broken and only the rubber is holding the air, so the tire can burst without warning.
-
41. Which of these counts as a serious traffic violation for a commercial driver license holder?
Show answer
Answer C: Speeding 15 miles per hour or more above the limit
Excessive speeding, reckless driving, improper lane changes, following too closely and texting while driving are all serious traffic violations.
-
42. A hazard suddenly appears ahead and you must act. Which is usually the faster way to avoid it in a heavy vehicle?
Show answer
Answer B: Steering around it, because you can usually turn faster than you can stop
Stopping distance at speed is very long, so a quick turn out of the way, when there is room, avoids the crash sooner than braking.
-
43. Your load projects more than 4 feet beyond the rear of the vehicle. How must the projecting end be marked?
Show answer
Answer A: With a red or orange flag by day and a red lamp after dark
Federal rules require a warning flag on a rear projecting load in daylight and a red lamp on the end of it when lights are required.
-
44. At the scale your tractor drive axles are overweight while the trailer axles have room. Sliding the trailer tandems forward will do what?
Show answer
Answer C: Move weight off the drive axles and onto the trailer axles
Sliding the trailer tandems forward brings the rear support closer to the load, so the trailer axles pick up more weight and the drive axles carry less; sliding them rearward does the opposite.
-
45. Where on a tire is tread depth measured?
Show answer
Answer C: In a major tread groove, away from any tie bar or wear indicator
Depth is taken in a major groove and away from the raised tie bars and wear indicators, which would give a shallower and misleading reading.
-
46. You are asked to drive a truck loaded with enough hazardous materials to require placards. What must you have?
Show answer
Answer C: A hazardous materials endorsement on your commercial driver license
Driving a vehicle that must be placarded requires the H endorsement, which involves a separate knowledge test and a security background check.
-
47. When traction is poor, such as on packed snow, how should you speed up?
Show answer
Answer C: Very gradually, so the drive wheels do not spin
Gentle throttle keeps the drive wheels from breaking traction, because spinning wheels give up both grip and directional control.
-
48. An intermodal container is being carried on an ordinary flatbed rather than on a container chassis. What does that mean for securement?
Show answer
Answer B: It must be secured with tiedowns that meet the container securement requirements
A container carried on a vehicle that is not fitted with integral locking devices has to be secured to the deck with tiedowns that satisfy the rules for containers.
-
49. Why must the steering wheel be moved only a small amount at a time while backing?
Show answer
Answer B: Because a small turn of the wheel produces a large change at the rear of the vehicle
In reverse, the effect of the steering is greatly magnified at the back of the vehicle, so a small correction is usually all that is needed.
-
50. On a set of dual tires, which condition must be reported as a defect?
Show answer
Answer D: The two tires are touching each other or rubbing on part of the vehicle
Duals that touch each other or the vehicle overheat and wear quickly, so they must be separated by proper spacing and inflation before driving.